ED Decision 2003/10/RM
1 Applicability
This ETSO gives the requirements that new models of emergency evacuation slides, ramps, ramp/slides, and slide/rafts that are manufactured on or after the date of this ETSO must meet in order to be identified with applicable ETSO marking.
Type I- Inflatable Slide
Type II- Inflatable Slide/Raft
Type III- Inflatable Exit Ramp
Type IV- Inflatable Exit Ramp/Slide
2 Procedures
2.1 General
Applicable procedures are detailed in CS-ETSO Subpart A.
2.2 Specific
None.
3 Technical Conditions
3.1 Basic
3.1.1 Minimum Performance Standard
Standards set forth in Appendix 1, Federal Aviation Administration Standards for emergency evacuation slides, ramps, ramp/slides, and slide/rafts, as amended and supplemented by this ETSO.
Where applicable, instead of the referenced FAA documents/paragraph the corresponding IR, CS or ETSO document/paragraph shall be used, when available.
3.1.2 Environmental Standard
See CS-ETSO Subpart A paragraph 2.1.
3.1.3 Computer Software
None.
3.2 Specific
None
4 Marking
4.1 General
Marking is detailed in CS-ETSO Subpart A paragraph 1.2.
4.2 Specific
The component also must be marked with the applicable emergency evacuation device type: "Type I, Type II, Type III, or Type IV." Type II devices shall also be marked with the rated and overload capacities and the weight of the device including any accessories required by this ETSO.
5 Availability of Referenced Document
See CS-ETSO Subpart A paragraph 3.
ETSO-C69c sets requirements for new emergency evacuation slides, ramps, ramp/slides, and slide/rafts, including marking with device type and, for Type II, rated and overload capacities.
* Summary by Aviation.Bot - Always consult the original document for the most accurate information.
Loading collections...