ETSO-C69c

• ED Decision 2003/10/RM found in: CS-ETSO Amdt 17 - European Technical Standard Orders (Oct 2026)

#### ETSO-C69c *ED Decision 2003/10/RM* ##### **Emergency Evacuation Slides, Ramps, Ramp/Slides and Slide/Rafts** **1 Applicability** This ETSO gives the requirements that new models of emergency evacuation slides, ramps, ramp/slides, and slide/rafts that are manufactured on or after the date of this ETSO must meet in order to be identified with applicable ETSO marking. Type I- Inflatable Slide Type II- Inflatable Slide/Raft Type III- Inflatable Exit Ramp Type IV- Inflatable Exit Ramp/Slide **2 Procedures** 2.1 General Applicable procedures are detailed in CS-ETSO [Subpart A](#_DxCrossRefBm920220672). 2.2 Specific None. **3 Technical Conditions** 3.1 Basic 3.1.1 Minimum Performance Standard Standards set forth in [Appendix 1](#_DxCrossRefBm920220751), Federal Aviation Administration Standards for emergency evacuation slides, ramps, ramp/slides, and slide/rafts, as amended and supplemented by this ETSO. Where applicable, instead of the referenced FAA documents/paragraph the corresponding IR, CS or ETSO document/paragraph shall be used, when available. 3.1.2 Environmental Standard See CS-ETSO Subpart A paragraph 2.1. 3.1.3 Computer Software None. 3.2 Specific None **4 Marking** 4.1 General Marking is detailed in CS-ETSO Subpart A paragraph 1.2. 4.2 Specific The component also must be marked with the applicable emergency evacuation device type: "Type I, Type II, Type III, or Type IV." Type II devices shall also be marked with the rated and overload capacities and the weight of the device including any accessories required by this ETSO. **5 Availability of Referenced Document** See CS-ETSO Subpart A paragraph 3.