ED Decision 2016/013/R
1 Applicability
This ETSO provides the requirements which Nickel-Cadmium, Nickel Metal-Hydride, and Lead-Acid Batteries that are designed and manufactured on or after the applicability date of this ETSO must meet in order to be identified with the applicable ETSO marking.
2 Procedures
2.1 General
Applicable procedures are detailed in CS-ETSO, Subpart A.
2.2 Specific
None.
3 Technical Conditions
3.1 Basic
3.1.1 Minimum Performance Standard
Standards set forth in the RTCA DO-293A, Minimum Operational Performance Standards (MPS) for Nickel-Cadmium, Nickel Metal-Hydride, and Lead-Acid Batteries, dated 12/2/2009, as amended according to Appendix 1 to this ETSO.
3.1.2 Environmental Standard
Nickel-Cadmium, Nickel Metal-Hydride, and Lead-Acid Batteries shall be tested according to the conditions specified in RTCA DO-293A.
Where the RTCA DO-293A quotes the RTCA DO-160 standard, the applicable DO-160 standard revision is defined in CS-ETSO, Subpart A, paragraph 2.1.
3.1.3 Computer Software
See CS-ETSO, Subpart A, paragraph 2.2.
3.1.4 Electronic Hardware Qualification
See CS-ETSO, Subpart A, paragraph 2.3.
3.2 Specific
None.
3.2.1 Failure Condition Classification
See CS-ETSO, Subpart A, paragraph 2.4.
4 Marking
4.1 General
Marking as detailed in CS-ETSO, Subpart A, paragraph 1.2.
4.2 Specific
At least one major component shall be marked permanently and legibly with all the information in RTCA DO-293A, section 1.10, as modified by Appendix 1.
5 Availability of Referenced Document
See CS-ETSO, Subpart A, paragraph 3.
[Amdt ETSO/11]
This ETSO requires Nickel-Cadmium, Nickel Metal-Hydride, and Lead-Acid Batteries designed and manufactured on or after its applicability date to meet RTCA DO-293A standards, as amended, and to be marked per its Appendix
* Summary by Aviation.Bot - Always consult the original document for the most accurate information.
Loading collections...