AMC 25.851(c) Alternative fire-extinguishing agents

• ED Decision 2012/008/R found in: CS-25 Amdt 27 - Large Aeroplanes (Jan 2023)

AMC 25.851(c) Alternative fire-extinguishing agents ED Decision 2012/008/R 1. General The Montreal Protocol, in existence since 1987, is an international agreement to phase out production and use of ozone-depleting substances, including halogenated hydrocarbons also known as Halon. The Montreal Protocol prohibits the manufacture or import of new Halon in all developed countries as of 1 January, 1994. The US Environmental Protection Agency (EPA) has released a regulation banning the intentional release of Halons during repair, testing, and disposal of equipment containing Halons and during technician training. However, the EPA has provided the aviation industry an exemption from their ban on the intentional release of Halon in determining compliance with airworthiness standards. A European regulation[[7]](#_ftn7) governing substances that deplete the ozone layer was also published, containing initial provisions for Halon phase-out, but also exemptions for critical uses of Halon, including fire-extinguishing in aviation. It should be noted that the exemptions were predicated on the basis that there were, at that time, no suitable alternate agents or systems available for use on commercial transport category aeroplanes. ‘Cut-off’ dates (i.e. Halon no longer acceptable in new applications for type certification) and ‘end’ dates (i.e. Halon no longer acceptable for use in aircraft) have been subsequently established by a new regulation in 2010[[8]](#_ftn8), as presented in Table 4.1 below: Table 4.1: ‘Cut-off’ and ‘end’ dates <table border="1" cellpadding="0" cellspacing="0" width="95%"><thead><tr><td rowspan="2" width="23%"><p><b>Aircraft compartment</b></p></td><td rowspan="2" width="15%"><p><b>Type of extinguisher</b></p></td><td rowspan="2" width="21%"><p><b>Type of Halon</b></p></td><td colspan="2" width="38%"><p><b>Dates</b></p></td></tr><tr><td valign="top" width="19%"><p><b>Cut-off</b></p></td><td valign="top" width="19%"><p><b>End</b></p></td></tr></thead><tr><td valign="top" width="23%"><p>Inerting of fuel tanks</p></td><td valign="top" width="15%"><p>Fixed</p></td><td valign="top" width="21%"><p>1301</p><p>2402</p></td><td valign="top" width="19%"><p>31 December 2011</p></td><td valign="top" width="19%"><p>31 December 2040</p></td></tr><tr><td valign="top" width="23%"><p>Lavatory waste receptacles</p></td><td valign="top" width="15%"><p>Built-in</p></td><td valign="top" width="21%"><p>1301</p><p>1211</p><p>2402</p></td><td valign="top" width="19%"><p>31 December 2011</p></td><td valign="top" width="19%"><p>31 December 2020</p></td></tr><tr><td valign="top" width="23%"><p>Dry bays</p></td><td valign="top" width="15%"><p>Fixed</p></td><td valign="top" width="21%"><p>1301</p><p>1211</p><p>2402</p></td><td valign="top" width="19%"><p>31 December 2011</p></td><td valign="top" width="19%"><p>31 December 2040</p></td></tr><tr><td valign="top" width="23%"><p>Cabins and crew compartments</p></td><td valign="top" width="15%"><p>Hand (portable)</p></td><td valign="top" width="21%"><p>1211</p><p>2402</p></td><td valign="top" width="19%"><p>31 December 2014</p></td><td valign="top" width="19%"><p>31 December 2025</p></td></tr><tr><td valign="top" width="23%"><p>Propulsion systems and Auxiliary Power Units</p></td><td valign="top" width="15%"><p>Built-in</p></td><td valign="top" width="21%"><p>1301</p><p>1211</p><p>2402</p></td><td valign="top" width="19%"><p>31 December 2014</p></td><td valign="top" width="19%"><p>31 December 2040</p></td></tr><tr><td valign="top" width="23%"><p>Normally unoccupied cargo compartments</p></td><td valign="top" width="15%"><p>Built-in</p></td><td valign="top" width="21%"><p>1301</p><p>1211</p><p>2402</p></td><td valign="top" width="19%"><p>31 December 2018</p></td><td valign="top" width="19%"><p>31 December 2040</p></td></tr></table> 2 Lavatory extinguishing systems and agents Historically, Halon 1301 has been the most widespread agent used in lavatory extinguishing (lavex) systems, to be used in the event of a Class A fire. Any alternative acceptable fire-extinguishing agent meeting the Minimum Performance Standards (MPS) laid down in Appendix D to Report DOT/FAA/AR-96/122 of February 1997, which includes the ability to extinguish a Class A fire and, in case of discharge, does not create an environment that exceeds the chemical agent’s ‘No Observable Adverse Effect Level’ (NOAEL) will be acceptable. Research and testing have shown that there are suitable alternatives to Halon for built-in fire extinguishers in aircraft lavatories meeting the MPS for effectiveness, volume, weight and toxicology. Currently HFC-227ea or HFC-236fa are widely used on large aeroplanes and usually considered acceptable by EASA. 3 Hand fire extinguishers and agents Historically, Halon 1211 has been the most widespread agent in handheld (portable) fire extinguishers to be used in aircraft compartments and cabins. Minimum Performance Standards (MPS) for the agents are laid down in Appendix A to Report DOT/FAA/AR-01/37 of August 2002, while acceptable criteria to select the fire extinguishers containing said agents are laid down in the FAA Advisory Circular AC 20-42C. Version D of the same AC (published in 2011) would be preferred when the needed supporting guidance material has been released. Three agent alternatives to Halon are presently known meeting the MPS: HFC-227ea, HFC-236fa and HFC Blend B. However, these agents are significantly heavier and occupy a greater volume than Halon 1211. This may indirectly (i.e. additional weight of the fire extinguisher and additional weight of the structures supporting it) increase CO2 emissions. Furthermore, some of these agents have also been identified as having a global warming potential much higher than Halon. Therefore, further research is underway to develop additional alternatives to Halon 1211 for hand fire extinguishers. Should an applicant wish to propose, even before the end of 2014, any alternative agent for hand fire extinguishers meeting the mentioned MPS, the EASA will initiate a Certification Review Item addressing the use of such an alternate fire-extinguishing agent. 4 Fire protection of propulsion systems and APU Historically, Halon 1301 has been the most widespread agent used in engine nacelles and APU installations to protect against Class B fires. The MPS for agents to be used in these compartments are particularly demanding because of the presence of fuel and other volatile fluids in close proximity to high temperature surfaces, not to mention the complex air flows and the extremely low temperatures and pressures surrounding the nacelles. Various alternatives are being developed (e.g. FK-5-1-12). The FAA has issued “Minimum Performance Standards (MPS) for Halon replacement in fire-extinguishing agents/systems of civil aircraft engine and APU compartments (MPSHRe rev03)” and intends to issue rev04. Should an applicant wish to propose, even before the end of 2014, any alternative agent for Class B fire extinction in engine or APU compartments, even in the absence of a published MPS, the EASA will initiate a Certification Review Item addressing the use of such an alternate fire-extinguishing agent. 5 Fire protection of cargo compartments — Gaseous agents MPS for cargo compartment fire suppression systems have already been published in the Report DOT/FAA/AR-00/28 of September 2000. However, to date there are no known and sufficiently developed alternatives to Halon 1301. Should the EASA be approached with the intent to utilise for the product an alternate agent or alternate gaseous fire-extinguishing system in lieu of a Halon 1301 system, then the recommended approach would be to perform testing on the product which meets the Minimum Performance Standards for that application as developed by the International Halon Replacement Working Group. The International Halon Replacement Working Group was established in October 1993. This group was tasked to work towards the development of minimum performance standards and test methodologies for non-Halon aircraft fire suppression agents/systems in cargo compartments, engine nacelles, handheld extinguishers, and lavatory waste receptacles. The International Halon Replacement Working Group has been expanded to include all system fire protection R&D for aircraft and now carries the name ‘International Aircraft Systems Fire Protection Working Group’. To ensure acceptable means of compliance, the following must be provided: a. The test data and gaseous agent distribution profiles which meet the certification criteria as expressed below and in the Minimum Performance Standards as developed by the FAA Technical Center as part of the International Halon Replacement programme. (See paragraph 7 for the listing of the references.) b. A system description document that includes a description of the distribution of the gaseous agent under test conditions in the cargo compartment. c. A detailed test plan. d. Chemical data which describes the agent and any toxicity data. 5.1 Pre-test considerations: a. An EASA accepted analyser (for example, Statham-derivative analyser) capable of measuring the agent distribution profile in the form of volumetric concentration is required. b. An EASA accepted analyser (for example, Statham-derivative analyser) and associated hardware are configured for the particular application. c. The fire suppression system should be completely conformed prior to the test. d. The fire extinguisher bottle(s) should be serviced and prepared for the prescribed test(s). 5.2 Test procedures: a. Perform the prescribed distribution test in accordance with the test plan approved by the Agency. (See Paragraph 7 in AMC 25.851(b) for guidance on probe placement.) b. An EASA accepted analyser (for example, Statham-derivative analyser) should record the distribution profile as volumetric concentration for the agent. 5.3 Test result evaluation: a. Produce the data from the EASA accepted analyser (for example, Statham-derivative analyser) in graphical format. This format should be the volumetric concentration of the agent versus time. A specific percentage of volumetric initial concentration and a specific percentage of volumetric metered concentration for the length of the test duration as determined by previous testing conducted per the established Minimum Performance Standards are required for airworthiness approval of cargo compartment systems. b. Using the appropriate MPS evaluation criteria, evaluate the distribution profile of the agent for acceptable performance. The acceptability of the test data would be dependent upon the distribution profile and duration exhibited by each probe per (1) above and Paragraph 7 for cargo compartment fire-extinguishing systems. 6. EVALUATION OF ALTERNATE LIQUID AGENT AND FIRE EXTINGUISHING/SUPPRESSION SYSTEMS The FAA Technical Center has released a Technical Note (ref. f in paragraph 7 below) that represents the latest Minimum Performance Standards (MPS) for a water spray system. However, as mentioned within the body of the report, additional developmental testing would be needed for the product and the FAA to be approached regarding certification of such a system. Additional testing would be required to demonstrate compliance with an aerosol spray. The Technical Center continues to perform research towards identifying alternate liquid and other fire-extinguishing/suppression systems. Acceptable means of compliance for these immature systems are beyond the scope of this AMC. Future revisions of this AMC will be accomplished as soon as suitable standards are developed for these systems. If it is proposed to use a liquid fire-extinguishing agent or system for the product, the EASA should be contacted. The EASA will initiate a Certification Review Item addressing the use of an alternate fire-extinguishing agent or system. 7. REFERENCES a. Report No FAA-RD-71-68, Fire Extinguishing Methods for New Passenger Cargo Aircraft, dated November 1971. b. UK Civil Aviation Authority (CAA) Paper 91003, Cargo Bay Fire Suppression, dated March 1991. c. Report No DOT/FAA/AR-96/5, Evaluation of Large Class B Cargo Compartment’s Fire Protection, dated June 1996. d. Report No DOT/FAA/AR-96/122, Development of a Minimum Performance Standard for Lavatory Trash Receptacle Automatic Fire Extinguishers, dated February 1997. e. Report No DOT/FAA/AR-00-28, Development of a Minimum Performance Standard for Aircraft Cargo Compartment Gaseous Fire Suppression Systems, dated September 2000. f. Report No DOT/FAA/AR-TN01/1, Water Spray as a Fire Suppression Agent for Aircraft Cargo Compartment Fires, dated March 2001. g. Report No DOT/FAA/AR-01/37, Development of a Minimum Performance Standard for Hand-Held Fire Extinguishers as a Replacement for Halon 1211 on Civilian Transport Category Aircraft, dated August 2002. h. 2010 Report of the UN Halons Technical Options Committee – 2010 Assessment i. FAA Advisory Circular AC 20-42C, Hand Fire Extinguishers for use in Aircraft, dated 07 March 1984. j. FAA Advisory Circular AC 20-42D, Hand Fire Extinguishers for use in Aircraft, dated 14 January 2011. [Amdt 25/12] --- [[7]](#_ftnref7) Regulation (EC) No 2037/2000 of the European Parliament and of the Council of 29 June 2000 on substances that deplete the ozone layer. [[8]](#_ftnref8) Commission Regulation (EU) No 744/2010 of 18 August 2010 amending Regulation (EC) No 1005/2009 of the European Parliament and of the Council on substances that deplete the ozone layer, with regard to the critical uses of halon (OJ L 218, 19.8.2010, p. 2).