CS 25.305 Strength and deformation

• ED Decision 2005/006/R found in: CS-25 Amdt 27 - Large Aeroplanes (Jan 2023)

CS 25.305 Strength and deformation ED Decision 2005/006/R (a) The structure must be able to support limit loads without detrimental permanent deformation. At any load up to limit loads, the deformation may not interfere with safe operation. (b) The structure must be able to support ultimate loads without failure for at least 3 seconds. However, when proof of strength is shown by dynamic tests simulating actual load conditions, the 3-second limit does not apply. Static tests conducted to ultimate load must include the ultimate deflections and ultimate deformation induced by the loading. When analytical methods are used to show compliance with the ultimate load strength requirements, it must be shown that – (1) The effects of deformation are not significant; (2) The deformations involved are fully accounted for in the analysis; or (3) The methods and assumptions used are sufficient to cover the effects of these deformations. (c) Where structural flexibility is such that any rate of load application likely to occur in the operating conditions might produce transient stresses appreciably higher than those corresponding to static loads, the effects of this rate of application must be considered. (d) Reserved (e) The aeroplane must be designed to withstand any vibration and buffeting that might occur in any likely operating condition up to VD/MD, including stall and probable inadvertent excursions beyond the boundaries of the buffet onset envelope. This must be shown by analysis, flight tests, or other tests found necessary by the Agency. (f) Unless shown to be extremely improbable, the aeroplane must be designed to withstand any forced structural vibration resulting from any failure, malfunction or adverse condition in the flight control system. These loads must be treated in accordance with the requirements of [CS 25.302](#_DxCrossRefBm1709820909). [Amdt 25/1]