ETSO-C25a

• ED Decision 2003/10/RM found in: CS-ETSO Amdt 17 - European Technical Standard Orders (Oct 2026)

#### ETSO-C25a *ED Decision 2003/10/RM* ##### **Aircraft Seats and Berths (Type I Transport 6g Forward Load)** **1 Applicability** This ETSO gives the requirements which seats, used in transport category aircraft for which an application for type certificate was made prior to March 5, 1952, that are manufactured on or after the date of this ETSO must meet in order to be identified with the applicable ETSO marking. **2 Procedures** 2.1 General Applicable procedures are detailed in CS-ETSO [Subpart A](#_DxCrossRefBm920220672). 2.2 Specific None. **3 Technical Conditions** 3.1 Basic 3.1.1 Minimum Performance Standard Standards set forth in National Aircraft Standard Specification 806, revised January 1, 1956, as amended and supplemented by this ETSO: Exceptions (i) The ultimate loads corresponding to the aircraft reduced weight gust load factor or the airplane designer’s special requirements may exceed the ultimate down loads for Type I seats specified in subparagraph 4.1.2 of NAS 806. For the purpose of this order, in order to provide for such loading conditions, the ultimate down loads specified in table 1 of 4.1.2 for Type I seats shall be 1,000 pounds (6g) instead of 765 pounds. (ii) To insure that pilot and copilot seats will provide for the rearwards loads resulting from the application of pilot forces to the flight controls, such seats shall withstand a rearward load of 450 pounds. The load shall be applied 8 inches above the intersection of the seat back with the seat bottom. (iii) The weight of the seat or berth times the appropriate „g“ value shall be added to the design ultimate load specified in subdivision (i) and in subparagraph 4.1.2 of NAS 806. (iv) For the purpose of this order, 4.3(c) of NAS 806 should read: „that the structure is capable of supporting without failure for at least 3 seconds the ultimate loads specified in this order when applied separately.“ 3.1.2 Environmental Standard None. 3.1.3 Computer Software None 3.2 Specific None. **4 Marking** 4.1 General Marking is detailed in CS-ETSO Subpart A paragraph 1.2. 4.2 Specific None. **5 Availability of Referenced Document** See CS-ETSO Subpart A paragraph 3.