CS 29.1385 Position light system installation

• ED Decision 2003/16/RM found in: CS-29 Amdt 11 - Large Rotercraft (Feb 2023)

CS 29.1385 Position light system installation ED Decision 2003/16/RM (a) General. Each part of each position light system must meet the applicable requirements of this paragraph and each system as a whole must meet the requirements of [CS 29.1387](#_DxCrossRefBm1178332150) to [29.1397](#_DxCrossRefBm1178332149). (b) Forward position lights. Forward position lights must consist of a red and a green light spaced laterally as far apart as practicable and installed forward on the rotorcraft so that, with the rotorcraft in the normal flying position, the red light is on the left side, and the green light is on the right side. Each light must be approved. (c) Rear position light. The rear position light must be a white light mounted as far aft as practicable, and must be approved. (d) Circuit. The two forward position lights and the rear position light must make a single circuit. (e) Light covers and colour filters. Each light cover or colour filter must be at least flame resistant and may not change colour or shape or lose any appreciable light transmission during normal use. CS 29.1385 Position light system installation ED Decision 2003/16/RM (a) General. Each part of each position light system must meet the applicable requirements of this paragraph and each system as a whole must meet the requirements of [CS 29.1387](#_DxCrossRefBm1513259736) to [29.1397](#_DxCrossRefBm1513259735). (b) Forward position lights. Forward position lights must consist of a red and a green light spaced laterally as far apart as practicable and installed forward on the rotorcraft so that, with the rotorcraft in the normal flying position, the red light is on the left side, and the green light is on the right side. Each light must be approved. (c) Rear position light. The rear position light must be a white light mounted as far aft as practicable, and must be approved. (d) Circuit. The two forward position lights and the rear position light must make a single circuit. (e) Light covers and colour filters. Each light cover or colour filter must be at least flame resistant and may not change colour or shape or lose any appreciable light transmission during normal use. #### CS 29.1385 Position light system installation *ED Decision 2003/16/RM* (a) *General*. Each part of each position light system must meet the applicable requirements of this paragraph and each system as a whole must meet the requirements of [CS 29.1387](#_DxCrossRefBm1685772615) to [29.1397](#_DxCrossRefBm1685772614). (b) *Forward position lights.* Forward position lights must consist of a red and a green light spaced laterally as far apart as practicable and installed forward on the rotorcraft so that, with the rotorcraft in the normal flying position, the red light is on the left side, and the green light is on the right side. Each light must be approved. (c) *Rear position light.* The rear position light must be a white light mounted as far aft as practicable, and must be approved. (d) *Circuit*. The two forward position lights and the rear position light must make a single circuit. (e) *Light covers and colour filters.* Each light cover or colour filter must be at least flame resistant and may not change colour or shape or lose any appreciable light transmission during normal use.