Article 5 -- Declaration of design compliance of the ATM/ANS equipment

• Regulation (EU) 2023/1768 found in: ATM/ANS Equipment (2023/1769 and 2023/1768) Part-DPO Part-ATM/ANS.EQMT (Nov 2024)

Article 5 — Declaration of design compliance of the ATM/ANS equipment Regulation (EU) 2023/1768 1.         The following ATM/ANS equipment when it generates, receives, and transmits data and/or signals in space for the purpose of ensuring safe and interoperable air navigation shall be issued with a declaration of design compliance as set out in Annex III: (a)       equipment supporting ground-to-ground communications; (b)       equipment supporting navigation or surveillance. 2.         Declarations of design compliance shall be issued by organisations involved in the design or production of ATM/ANS equipment and which are approved in accordance with Implementing Regulation (EU) 2023/1769. 3.         Declarations of design compliance of the ATM/ANS equipment shall be issued for an unlimited duration. Declarations shall remain valid unless they have been deregistered in accordance with point DPO.AR.C.015(g)(6) of Annex I to Implementing Regulation (EU) 2023/1769 as a result of one of the following: (a)       the ATM/ANS equipment no longer complies with the detailed specifications which enabled the declaration to be issued; (b)       the issuer of the declaration no longer complies with the applicable requirements of Implementing Regulation (EU) 2023/1769 or its approval has been surrendered, suspended or revoked; (c)       the ATM/ANS equipment has proved to give rise to unacceptable risk or unacceptable performance in service; (d)       the organisation has withdrawn the declaration of design compliance. 4.         By way of derogation from paragraph 1, ATM/ANS equipment that is solely being used in a limited part of airspace outside of the ICAO EUR region with low traffic volume, and where that part of the airspace borders only with airspace under the responsibility of a third country, shall not be required to be issued with a declaration of design compliance. In such a case, the ATM/ANS equipment shall be issued with a statement of compliance in accordance with [Article 6](#_DxCrossRefBm1741288283). 5.         As regards the ATM/ANS equipment of the European Geostationary Navigation Overlay Service (EGNOS) system, the declaration of design compliance as set out in Annex III to this Regulation shall be issued by the European Union Agency for the Space Programme (EUSPA) established by Regulation (EU) 2021/696, which shall be considered as an organisation involved in the design or production of EGNOS equipment. 6.         Points [ATM/ANS.EQMT.DEC.005](#_DxCrossRefBm1741288336) and [ATM/ANS.EQMT.DEC.045](#_DxCrossRefBm1741288335) of Annex III shall not be applicable to EUSPA. EUSPA shall ensure that the Agency is given access to evidence from the different entities involved in the design and production of the ATM/ANS equipment of the EGNOS system, in order to determine continued compliance with the applicable technical specifications against which the ATM/ANS equipment declaration was made in accordance with Annex III.