ED Decision 2021/007/R
Compliance with point 21.A.101(h) is demonstrated through compliance with Amdt 19 to CS 25.571 or subsequent amendments, or with the following:
(a) For turbine-powered large aeroplanes with a certified maximum take-off weight (MTOW) greater than 34Â 019Â kg (75Â 000Â lbs):
(1) For changes that affect or introduce fatigue critical structures susceptible to widespread fatigue damage (WFD), WFD evaluations should substantiate freedom from WFD up to the existing limit of validity (LOV) or a new reduced LOV approved by EASA;
(2) The extension of an existing LOV is a major change.
(3) The extent of the test evidence required in support of the WFD evaluation should be agreed with EASA;
(4) Inspections and other maintenance actions upon which the LOV is dependent are established and submitted to EASA for approval in accordance with point 21.A.7 of Part 21;
(5) AMC 20-20B paragraph 8 contains additional guidance on this subject.
(b) For turbine-powered large aeroplanes certified to carry 30 passengers or more, or with a payload capacity of 3Â 402Â kg (7Â 500Â lbs) or more:
(1) For changes that affect or introduce fatigue critical structures, damage-tolerance evaluations must be performed according to the certification basis of the aeroplane unless it precedes JAR 25.571 Change 7 or 14 CFR §25.571 Amendment 45, in which case the certification basis for the change should be:
(i) JAR 25.571 Change 7 or 14 CFR §25.571 Amendment 45, or later amendments; or
(ii) the specifications used for compliance with the applicable points of Part-26 for the structures affected by the change.
(2) Develop or amend the list of fatigue-critical modified structures (FCMS) as necessary and make it available to aircraft operators as part of the ICA of the change.
(c) For turbine-powered large aeroplanes, the baseline corrosion prevention and control programme is amended or supplemented to address the influence of the change on the effectiveness of the programme, as necessary.
AMC1 21.A.101(h) provides compliance methods for changes to large aeroplanes, covering WFD evaluations, LOV extensions, damage-tolerance assessments, FCMS lists, and corrosion programme adjustments.
* Summary by Aviation.Bot - Always consult the original document for the most accurate information.
Loading collections...