ED Decision 2003/10/RM
1 Applicability
This ETSO gives the requirements that flexible fuel and oil cell material which are manufactured on or after the date of this ETSO must meet in order to be identified with the applicable ETSO marking.
2 Procedures
2.1 General
Applicable procedures are detailed in CS-ETSO Subpart A.
2.2 Specific
None.
3 Technical Conditions
3.1 General
3.1.1 Minimum Performance Standard
Standards set forth in Federal Aviation Agency Standard, "Flexible Fuel and Oil Cell Material", dated August 1, 1963 (see Appendix 1).
3.1.2 Environmental Standard
See CS-ETSO Subpart A paragraph 2.1
3.1.3 Computer Software
None
4 Marking
4.1 General
Marking is detailed in CS-ETSO Subpart A paragraph 1.2; in addition, each flexible fuel and oil cell material shall be legibly and permanently marked with the following information:
(i) Type of fluid for which approved, i.e. fuel, or MIL-L-6082 oil, or MIL-L-7808 oil,
(ii) For oil cell material, the minimum and maximum temperature limit,
(iii) For oil cell material, the oil-dilution suitability.
4.2 Specific
None.
5 Availability of referenced documents
See CS-ETSO Subpart A paragraph 3.
Loading collections...