ED Decision 2003/10/RM
1 Applicability
This ETSO gives the requirements which static electrical power inverters that are manufactured on or after the date of this ETSO must meet in order to be identified with the applicable ETSO marking.
2 Procedures
2.1 General
Applicable procedures are detailed in CS-ETSO Subpart A.
2.2 Specific
None.
3 Technical Conditions
3.1 Basic
3.1.1 Minimum Performance Standard
Standards set forth in the attached Federal Aviation Administration Standard, „Airborne Static Electrical Power Inverters“dated July 25, 1963.
3.1.2 Environmental Standard
See CS-ETSO Subpart A paragraph 2.1.
3.1.3 Computer Software
None
3.2 Specific
None
4 Marking
4.1 General
Marking is detailed in CS-ETSO Subpart A paragraph 1.2; in addition to the markings required by this paragraph, the instrument must be marked to indicate:
— rated terminal voltage, frequency and number of phases
— rated power in volts amperes
— output load power factor
— maximum operating altitude.
4.2 Specific
None.
5 Availability of Referenced Document
See CS-ETSO Subpart A paragraph 3.
Loading collections...