ED Decision 2018/002/R
1 Applicability
This ETSO provides the requirements which Airborne Systems to be installed on Aircraft for Non Required Telecommunication Services (in Non Aeronautical Frequency Bands) (ASNRT) that are designed and manufactured on or after the date of this ETSO must meet in order to be identified with applicable ETSO marking.
Note: An antenna alone without an ASNRT controller does not fall under this standard.
2 Procedures
2.1 General
Applicable procedures are detailed in CS-ETSO Subpart A.
2.2 Specific
None.
3 Technical Conditions
3.1 Basic
3.1.1 Minimum Performance Standard
Standards set forth in the Appendix 1.
3.1.2 Environmental Standard
Equipment providing telecommunication services shall be tested in accordance with Appendix 1, Chapter 4 of this ETSO.
3.1.3 Software
See CS-ETSO, Subpart A, paragraph 2.2.
3.1.4 Airborne Electronic Hardware
See CS-ETSO Subpart A, paragraph 2.3.
3.2 Specific
None.
3.2.1 Failure Condition Classification
See CS-ETSO Subpart A, paragraph 2.4.
4 Marking
4.1 General
Marking is detailed in CS-ETSO, Subpart A, paragraph 1.2.
4.2 Specific
The label shall indicate the communication system or network used.
5 Availability of Referenced Document
See CS-ETSO, Subpart A, paragraph 3.
[Amdt ETSO/3]
[Amdt ETSO/13]
ETSO-2C514a sets requirements for Airborne Systems for Non Required Telecommunication Services (ASNRT), including Appendix 1 performance standards, environmental testing per Chapter 4, and label marking indicating the .
* Summary by Aviation.Bot - Always consult the original document for the most accurate information.
Loading collections...