AMC1
BFCL.215(d)(2)(ii) Commercial operation rating
ED Decision 2020/003/R
REFRESHER COURSE
(a) THEORETICAL KNOWLEDGE INSTRUCTION
The 6 hours of theoretical knowledge instruction should include at least all of the following:
(1) Evaluation of passengers:
(i) assessment of fitness of passengers;
(ii) criteria to decline to carry a passenger; and
(iii) special factors for disabled or limited mobility passengers;
(2) Passenger briefings:
(i) use of briefing cards;
(ii) pre-inflation briefing;
(iii) pre-launch briefing; and
(iv) pre-landing briefing;
(3) Passenger embarkation:
(i) procedures for safe embarkation;
(ii) use of ground crew to assist with embarkation;
(iii) positioning of passengers in the basket for weight, balance and management; and
(iv) factors concerning passengers’ personal property;
(4) Passenger care for landing:
(i) use of seats where fitted;
(ii) stowage of passengers’ personal equipment; and
(iii) special factors in case of more than 19 passengers on board, in which case an additional crew member is required in accordance with point BOP.ADD.410 of Annex II (Part-BOP);
(5) Emergency procedures:
(i) fire in the air;
(ii) fire on the ground;
(iii) fuel system failures;
(iv) deflation system failures;
(v) fast landing;
(vi) hard landing; and
(vii) passenger incapacitation in flight; and
(6) Documentation:
(i) loading calculation;
(ii) fuel calculation;
(iii) completion of passenger manifest; and
(iv) dealing with last-minute changes.
(b) TRAINING FLIGHT
(1) A training flight as stipulated in point BFCL.215(d)(2)(ii) should be a flight that:
(i) follows the content of the skill test for initial issue of the commercial operation rating as set out in AMC1 BFCL.215(b)(4); and
(ii) is conducted on a one-to-one basis between one pilot and one instructor only, with no other pilot on board who is taking credit for that flight.
(2) Each training flight should be preceded with a briefing and closed with a debriefing between the instructor and the candidate. In order to add value to the training flight, any element of flying a balloon where candidates feel they would benefit from instruction should be discussed. The flight should then be focused on those specific elements with an instructor demonstration prior to candidate practice being performed.
(3) The training flight may be conducted during CPB operation, provided that:
(i) abnormal and emergency procedures are simulated before or after the flight on the ground without passengers on board; and
(ii) passengers are made aware that the intended flight will be a training flight.
EASA balloon commercial rating refresher courses require 6 hours of theoretical knowledge instruction covering passenger evaluation, briefings, embarkation, landing care, emergency procedures, and documentation. A dedicated training flight, mirroring the skill test, must be conducted one-on-one with an instructor, focusing on areas needing improvement. Abnormal procedures are simulated without passengers.
* Summary by Aviation.Bot - Always consult the original document for the most accurate information.
Loading collections...