AMC1 ARA.FSTD.120
Continuation of an FSTD qualification
ED Decision 2012/006/R
GENERAL
(a) Objective Testing. During recurrent evaluations, the competent authority should wish to see evidence of the successful running of the QTG between evaluations. The competent authority should select a number of tests to be run during the evaluation, including those that may be cause for concern. Again adequate notification would be given when special equipment is required for the test.
(b) Essentially the time taken to run the objective tests depends upon the need for special equipment, if any, and the test system, and the FSTD cannot be used for subjective tests or other functions whilst testing is in progress.
(c) For a modern FSTD incorporating an automatic test system, four hours would normally be required. FSTDs that rely upon manual testing may require a longer period of time.
(d) Subjective Testing. Essentially the same subjective test routine should be flown as per the profile described in AMC1 ARA.FSTD.100(a)(3) with a selection of the subjective tests taken from CS-FSTD(A) or CS-FSTD(H), as appropriate.
(e) Normally, the time taken for recurrent subjective testing is about 4 hours, and the FSTD should not perform other functions during this time.
(f) To ensure adequate coverage of subjective and objective tests during a recurrent evaluation, a total of 8 hours should be allocated, (4 hours for a BITD). However, it should be remembered that any FSTD deficiency that arises during the evaluation could necessitate the extension of the evaluation period.
To maintain flight simulator (FSTD) qualification under EASA rules, recurrent evaluations require both objective and subjective testing. Authorities review QTG test results. Modern FSTDs need approximately 4 hours for each test type, while manual systems may require longer. A total of 8 hours should be allocated for recurrent evaluations.
* Summary by Aviation.Bot - Always consult the original document for the most accurate information.
Loading collections...