AviationBot
Navigate / EASA / CS E AMDT 5 / SUBPART E - TURBINE ENGINES: TYPE SUBSTANTIATION /

CS-E 640 Pressure Loads

EASA Logo

CS-E 640  Pressure Loads

ED Decision 2007/015/R

(See AMC E 640)

(a)     Static Pressure Loads

It must be established by test, validated analysis or combination thereof that all static parts which are subject to significant gas or liquid pressure loads will not, for a stabilised period of one minute:

(1)     Exhibit permanent distortion beyond serviceable limits or exhibit leakage which could result in a Hazardous Engine Effect when subjected to the greater of the following pressures:

(i)      1.1 times the maximum working pressure or,

(ii)     1.33 times the normal working pressure or,

(iii)     35 kPa above the normal working pressure, and

(2)     Exhibit fracture or burst when subjected to the greater of the following pressures:

(i)      1·15 times the maximum possible pressure or,

(ii)     1·5 times the maximum working pressure or,

(iii)     35 kPa above the maximum possible pressure.

(b)     Compliance with CS-E 640(a) must take account of

(1)     The operating temperature of the part,

(2)     Any other significant static loads in addition to pressure loads,

(3)     Minimum properties representative of both the material and the processes used in the construction of the part, and

(4)     Any adverse geometry conditions allowed by the type design.

[Amdt. No.: E/1]

Frequently Asked Questions

Compliance with CS-E 640(a) must account for the operating temperature of the part, any other significant static loads in addition to pressure loads, minimum properties representative of both the material and the processes used, and any adverse geometry conditions allowed by the type design.

* Aviation.Bot's Suggestion - Always consult the original regulation for confirmation

Static parts subject to significant pressure loads must not exhibit permanent distortion beyond serviceable limits or leakage resulting in a Hazardous Engine Effect when subjected to 1.1 times the maximum working pressure, 1.33 times the normal working pressure, or 35 kPa above the normal working pressure (whichever is greater) for one minute.

* Aviation.Bot's Suggestion - Always consult the original regulation for confirmation

CS-E 640 defines the pressure load requirements for engine static parts to ensure they can withstand specified pressures without distortion, leakage, fracture, or burst.

* Aviation.Bot's Suggestion - Always consult the original regulation for confirmation

Static parts must not fracture or burst when subjected to 1.15 times the maximum possible pressure, 1.5 times the maximum working pressure, or 35 kPa above the maximum possible pressure (whichever is greater).

* Aviation.Bot's Suggestion - Always consult the original regulation for confirmation

Related

AI for Aviation Professionals

Aviation.Bot is an AI tool that assists you with aviation compliance.